GNOIRDLY.
G5VORTMDS.
7.3.2 Set CEC control
Command
CECON.
CECOFF.
GCECSTAUS.
TVON.
TVOFF.
7.3.3 RS232 control settings
Command
RS232ON/+[X]:XXX
RS232ON/-[X]:XXX
29
Report the delay time of SYSTEM OFF when the
controller detects no IR sensor signal.
Report the detection method of input source.
5V/TMDS
Function
Enable CEC
Disable CEC
Report CEC state
Turn on display (e. g. TV)
Turn off display (e. g. TV)
Function
When detecting a trigger signal, automatically
send ASCII command XXX to the third-party
device (e. g. projector) whose baud rate is X.
X
Baud rate
1
2400
2
4800
3
9600
4
19200
5
38400
6
57600
7
115200
When detecting a triggering signal, automati-
cally send HEX command XXX to the third-party
device (e. g. projector) whose baud rate is X.
DETECT NO IR DELAY TIME 300S!
DETECT INPUT SOURCE USE 5V!
Feedback/Example
OPEN CEC FUNCTION!
CLOSE CEC FUNCTION!
CEC FUNCTION IS OPEN!
CEC TV POWER ON!
CEC TV POWER OFF!
Feedback/Explanation/Example
RS232ON/+3:123abc
Send the ASCII command "123abc"
to the third-party device whose
baud rate is 9600.
RS232ON/-3:30 31 32
Send the HEX command "30 31 32"
to the third-party whose baud rate
is 9600.