Installation - Taurus Alpatec RCMB231 Bedienungsanleitung

English
WALL HEATER
RCMB 231
DESCRIPTION
1 LCD screen
2 Low/High heat indicators
3 Open window indicator
4 ON/OFF switch
5 Function/Mode button
6 Program indicator
7 Timer indicator
8 Timer button
9 On/Standby button
10 Timer button
11 Hour/minute set button
12 Temperature selection button
13 – / Back button
14 OK/Confirm button
15 + / Forward button
16 Open window detection button
17 Day selection button
18 Weekly timer button
19 Timer on selection button
20 Timer edit button
21 Timer off selection button
- If the model of your appliance does not have
the accessories described above, they can
also be bought separately from the Technical
Assistance Service.
USE AND CARE:
- Fully extend the appliance's power cable befo-
re each use.
- Do not use the appliance if the on/off switch
does not work.
- If you use the appliance in a bathroom or simi-
lar place, unplug the appliance from the mains
when it is not in use, even if it is only for a short
while, as proximity to water involves a risk,
even if the appliance is disconnected.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the appliance.
- Never leave the appliance unattended while in
use.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance to dry textiles of any
kind.

INSTALLATION

- Be sure to remove all packaging material from
inside the appliance.
- Install the appliance away from flammable ma-
terial such as textiles, cardboard or paper, etc.
- Install the appliance a minimum distance of
50cm away from combustible materials, such
as curtains, furniture ...
- Ensure that neither the air access nor exit
become either totally or partially covered by
drapery, clothing, etc., as this increases the
risk of fire.
- Appliance must be installed at least 2 m above
the floor.
- In the event that the appliance is mounted on a
bathroom wall, position it in such a way that the
socket, power supply cable, switches or other
controls are not within the reach a person in
the bath, shower or at the wash-hand basin.
- This appliance must be fixed into a wall. The
minimum distance between the floor and the
lower part of the appliance is 1,8m
- The appliance requires suitable ventilation in
order to work properly. Leave a space of 30 cm
above the appliance and 25 cm on each side.
(Fig.1)
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.
- To achieve the highest efficiency from the
appliance and so as to be able to install the
appliance on a cold wall (an exterior wall)
and below a window. But never obstructing or
covering a ventilation area.
WALL ASSEMBLING:
- Securing to the wall (Fig.2): Use a pencil to
mark the right position to drill the wholes for the
wall plugs.