Battery Installation; Charging And Battery Maintenance - Radioddity FS-T2 Benutzerhandbuch

Belt clip
At the back of the radio has a clip slot, correctly align the back clip with the slot, then use the screws to
screw up the belt clip.

Battery installation

Before attaching or removing the battery, make sure your radio is powered off. Install the battery at the
top slot in place, then push the battery to lock it out. Conversely, push the locking-latch at the bottom
to open the battery cover.
Battery power display & Low battery alert
In the top-right corner of the display , there is a power indicator to show the battery level. When the
battery is indicated , the radio will ring every 10 seconds or after releasing the PTT key, to remind
you to replace the battery or charge.

Charging and battery maintenance

Charging
Battery should be fully charged before initial use. Optimum battery efficiency will be achieved after the
three full battery charge and discharge cycles.
1. Plug the USB cable into the power adapter.
2. Plug the AC adapter of the power adapter into the main AC outlet.
3. Connect micro-USB plug to the charger port at the back of radio.
Note: Radio should be turned OFF during a charge cycle.
03
Battery Maintenance
The battery for your radio comes uncharged from the factory; please let it charge for at least 3-4 hours
before you start using your radio.
Use only batteries approved by the original manufacturer.
Never attempt to disassemble your battery pack.
Do not expose your batteries to fire or intense heat
Dispose of batteries in accordance with local recycling regulations.
Prolonging your battery's life
Only charging batteries in normal room temperatures.
When charging a battery attached to the radio, power off the radio for a faster charge.
Before the charging is completed, do not unplug the power to the charger or remove the battery.
Never charge or use a wet battery.
Batteries wear out over time. When the radio is operated in a shorter time, please consider purchasing
a new battery to replace.
Battery's performance will be reduced in temperatures below Zero. When working in cold environments,
it is suggested to prepare a spare battery. Preferably inside your jacket or in a similar location in order
to keep the battery warm.
Dust can interfere with the connection between battery and the radio. If necessary wipe the contacts
with a clean cloth to ensure proper contact with radio and charger.
Storage
In order to prevent damage from over discharge, the battery must be left with partial power. This radio
uses a lithium-based battery and a 40% charge is recommended. This level minimizes age-related
capacity loss while keeping the battery in operating condition and allowing self-discharge.
04