Clear Tail
Clear tail only can be adjusted on the software. During the call, the transmitter releases the PTT
Programming software is available at www.radioddity.com/support.
Before programming, please purchase the programming cable, which is available on radioddity.com.
13
Appendix A. - Troubleshooting
Symptom
The radio
doesn't start
The battery dies
quickly
The LED indicates
reception, but the
speaker is silent.
Others can't hear
my transmission.
The radio transmits
without touching the
PTT.
Possible
Solution
The battery is too low.
Change or recharge the battery.
The battery isn't correctly
Remove the battery and reinstall it.
installed.
The battery is dead.
Purchase a new battery.
The battery isn't fully
Recharge the battery.
charged.
Turn up the volume.
Change your CTCSS or DCS to
Volume is too low.
match those you're trying to
CTCSS or DCS enabled.
communicate with.
Turn CTCSS or DCS off.
Change your CTCSS or DCS
Their CTCSS or DCS
Settings to match your peers.
settings don't match yours.
You're too far apart.
Turn VOX off.
The VOX is enabled.
Turn down VOX sensitivity.
VOX sensitivity is too high.
14