Clearing A Cutter Lock (1) - Citizen Systems CT-S601 II Benutzerhandbuch

CAUTION
 The print head is hot immediately after printing. Do not touch it.
 Do not touch the print head with bare hands or metal objects.
 Do not use alcohol or cleansers to clean the platen. Doing so may deteriorate the non-
adhesive properties of the platen.
 Do not push the platen with excessive force or with a sharp object, because doing so
could break the product.
 When cleaning the top cover paper eject slot or the auto cutter fixed blade, do not
touch the edge of the auto cutter fixed blade, or you may get hurt.
 Clean the product at appropriate intervals, because the way it becomes dirty depends
on the type of liner-free labels and the operating environment.

4.2 Clearing a Cutter Lock (1)

The ERROR LED flashes and the auto cutter blade remains extended because a
foreign object or paper jam is obstructing it.
If the ERROR LED is flashing, clear the locked cutter as shown below.
1. Press the cover open lever while the power is on.
2. Open the paper cover.
3. Remove any jammed paper including any scraps of paper. (Remove the paper roll
that is loaded in the holder also.)
4. Reload the paper roll and close the paper cover.
CAUTION
 The print head is hot immediately after printing. Do not touch it.
 Do not touch the print head with bare hands or metal objects.
If the paper cover does not open, the auto cutter blade is still extended (cutter
lock).
Refer to 4.3 Clearing a Cutter Lock (2)
— 47 —