Precautions For Installing The Printer - Citizen Systems CT-S601 II Benutzerhandbuch

3.9 Precautions for Installing the Printer

The printer can be used horizontally, vertically, or installed on a wall. However,
the CT-S601IIS (built-in power supply type) cannot be used vertically or installed
on a wall.
Use the optional stand for vertical applications, and the optional brackets for
wall installations. Please refer to the manual for further details.
Horizontal position
Change the paper near-end sensor settings for vertical and wall installations. (The
factory setting for the paper near-end sensor is for horizontal installations.)
CAUTION
Do not use the printer under the following conditions.
 Locations subject to vibration or instability.
 Locations that are very dirty or dusty
 Locations where the printer is not level.
• The printer may fall and cause an injury.
• The quality of printing may deteriorate.
 Oriented other than as specified.
• The printer may malfunction, be damaged, or cause an electric shock.
Precautions for horizontal installations
 Do not set cutting to full cut. Doing so may cause cutter jams.
Precautions for vertical/wall installations
 Adjust the paper near-end sensor.
Precautions for vertical installations
 The optional stand may fall over when you pull on partially cut thick paper.
Do not use thick paper.
Wall installation
Refer to 3.12 Adjusting the Paper Near-end Sensor
— 35 —
Vertical position