Ethernet (Lan)/Wireless Lan Interface Board - Citizen Systems CT-S601 II Benutzerhandbuch

Enabling and disabling auto reconnection
To change the setting of this feature, the following method is provided.
Press the FEED button 3 times during self test -> Auto reconnect = Valid
Press the FEED button 4 times during self test -> Auto reconnect = Invalid
At the end of self test, new setting will be printed as Auto reconnect [Valid] or
[Invalid]

3.5 Ethernet (LAN)/Wireless LAN Interface Board

This section provides an overview of the interface board. For details on this board,
including explanations about the USB host function and XML peripheral device
support,refer to the separate manual.
Connecting the Interface Cable
1. Turn off the power.
2. Orient the cable correctly and insert it into the connector.
3. Connect the other connector to a hub, router, or similar device.
CAUTION
 When disconnecting the cable, always hold the connector.
 Place the interface cable so people do not trip on it.
 Hold the connector of the LAN cable perpendicular and straight when connecting or
disconnecting it. Doing it at an angle may cause the connector to misconnect.
Connecting a Peripheral Device
1. Turn off the power.
2. Insert the cable of the peripheral device into the connector.
1 0
/ 1 0
0 B
A S
E
1 0
/ 1 0
0 B
A S
E
S W
— 24 —
Refer to 4.4 Self test