Lifted Hopper Door Support Rod Installation; Using The High-Pressure Water Gun (*); Using The Camera Kit (Optional) - Nilfisk RS 851 Betriebsanleitung

ENGLISH

LIFTED HOPPER DOOR SUPPORT ROD INSTALLATION

Before working under the lifted hopper door (44, Fig. G), it is necessary to install the support rod (17, Fig. F) according to the
following procedure.
Support rod installation
1. Remove the rod (17, Fig. F) from the housing and lift the door as necessary, then install the rod in the housing (18).
Support rod removal
2. Perform the procedures described in step 1 in the reverse order.

USING THE HIGH-PRESSURE WATER GUN (*)

(*) Optional
The machine is equipped with a high-pressure water system (optional) to be used for washing the machine or other purposes.
The following procedure refers to the high-pressure water gun use.
WARNING!
Do not run the high pressure pump when the water tanks are empty or low (the pump can be damaged).
1. Pick up the high-pressure water gun (9, Fig. E) inside the cab.
2. Withdraw part of the hose (21, Fig. F) and connect the gun (9, Fig. E) to the quick coupling (22, Fig. F).
3. Start the diesel engine at idle speed, as shown in the relevant paragraph.
4. Turn on the high-pressure pump by bringing the lever (8, Fig. E) in lower position.
5. If necessary, bleed the air from the system by turning the water gun knob completely counter-clockwise and by pressing the
water gun lever until the water comes out constantly and at low pressure.
Release the water gun lever and turn the knob clockwise to use the high pressure nozzle.
6. Run the engine at the desired speed.
7. Use the water gun by pressing the relevant trigger.
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing cleaning procedures using compressed
air or water gun.
WARNING!
Do not run the high pressure pump for long periods without using the water gun.
8. After using the water gun, perform steps 1 to 4 in the reverse order.

USING THE CAMERA KIT (optional)

1. To turn on the video system (1, Fig. AX) and the cameras (4 and 5), press the switch (2) when the ignition key (24, Fig. D) is
inserted. The monitor (1) will show the image of the front camera (4).
2. When the reverse gear is selected, the video system and the cameras turn on automatically, and the monitor will show the
image of the rear camera (5). For the functions of other switches on the right side of the display, refer to the camera kit Manual.
26
USER MANUAL
33018305(3)2010-01 A RS 851