D Is As Se Mb Li N G Th E Ap P Li Ance - SOLIS 8454 Bedienungsanleitung

Notes:
Thanks to the two different pulp filters, you can choose between having less or
●
more pulp in your juice.
More pulp: Select the pulp filter with the large holes (J).
Less pulp: Select the pulp filter with the small holes (E).
The pulp filter should be emptied once it is filled with pulp and pips.
●
If you want to empty the pulp filter while juicing, switch the appliance off with
●
the ON/OFF switch, pull the power plug, set the lever press arm to the highest
position and carefully remove the juicing cone and the pulp filter. Empty and
rinse the filter and the juicing cone and reinstall both parts in the appliance
(make sure that the pulp sieve is correctly positioned as described in section 5
on page 67) before plugging it back in and switching it on to continue juicing.
The pulp filter should never be too full, as this hinders the appliance from func-
●
tioning optimally resp. might cause damage to it.
Should the diameter of the fruit you wish to juice seem too large or too small
●
for the pressing cone, the fruit can still be placed on the juicing cone and be
pressed onto the juicing cone by hand to start the juicing rotation. The lever
press arm can remain in its folded-up position. Like this, practically all citrus
fruits can be juiced.
▲

D IS AS SE MB LI N G TH E AP P LI ANCE

1. Always switch the appliance off with the ON/OFF switch (position 0) first and
disconnect the power plug from the power socket.
2. Push the lever press arm up, away from the motor base, until it reaches the
highest position. Close the juice spout by folding it up into the no-drip position.
3. Hold the lever press arm and remove the pressing cone and, if mounted, the
dust cover by turning the pressing cone out of the lever press arm in a clockwise
motion and taking it off.
4. Carefully lift the juice collection tray with the pulp filter and the juicing cone.
Remove the juicing cone and the pulp filter from the juice collection tray over a
sink so that the pulp leftovers can be easily removed.
5. Take the drip tray out of the appliance.
6. Clean the single parts as described in the "Cleaning and Care" section on page
71.
Note: Should a little bit of juice drip onto the work surface, please always wipe it
off immediately to prevent the surface from being damaged.
GB
69