Setting The Sampling Rate For Outgoing Spdif Audio Signals; Showing Information About Spdif Audio Signals - G&D Audio-Transceiver-CAT Installationsanleitung

Setting the sampling rate for outgoing SPDIF audio signals

The signal extender supports various sampling rates for outgoing SPDIF audio signals.
NOTE: The setting
192 kHz
pling rate of 192 kHz or 176.4 kHz for the SPDIF audio signal.
How to select the sampling rate:
1. Use the terminal emulation program to establish a connection.
2. Use the
arrow keys
3. Press (repeatedly) to select one of the following settings:
Space
192 kHz: Audio signals are issued with a sampling rate of 192 kHz using the
SPDIF interface.
96 kHz: Audio signals are issued with a sampling rate of 96 kHz using the
SPDIF interface.
48 kHz:
Audio signals are issued with a sampling rate of 48 kHz using the
SPDIF interface.
4. Press S to save your settings.

Showing information about SPDIF audio signals

The menu Show SPDIF parameters
incoming SPDIF audio signals.
How to show SPDIF information in the terminal emulation program:
1. Use the terminal emulation program to establish a connection.
2. Use the arrow keys
3. Press to show information about the SPDIF audio signals in the terminal
Enter
emulation program.
is only available when the signal extender detects a sam-
to select the row
SPDIF Output
shows information about various parameters of
to select the row Show SPDIF parameters
.
.
Audio-Transceiver-CAT · 10
Configuration