Troubleshooting; Technical Data; Warranty; Ec Declaration Of Conformity - GreenWorks G60PHT Bedienungshandbuch

EN
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
7

TROUBLESHOOTING

Problem
The motor shuts
down whilst work-
ing.
The machine
smokes during op-
eration.
The motor is on,
blades do not
move.
Too much noise
and/or vibration is
experienced while
working.
8

TECHNICAL DATA

Voltage
No load speed
Blade speed
Blade length
Possible cause Solution
Make sure that
The battery pack is you tighlty instal-
not installed tight- led the battery
ly. pack in the ma-
chine.
The battery pack is Charge the battery
out of power. pack.
The machine has Do not use the ma-
damage. chine and speak to
service center.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery.
3. Speak to serv-
ice center.
Do not use the ma-
The machine has
chine and speak to
damage.
service center.
Remove battery
The blades are then clear block-
blocked. age from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are loos-
3. Inspect for
en.
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and speak to
damage.
service center.
60V
3000
(±10%) /min
3000
(±10%) /min
510 mm
English
Cutting capacity
Weight (without battery pack)
Measuered sound pressure level
Guaranteed sound power level
Vibration
Uncertainty
9

WARRANTY

(The full warranty terms and conditions can be found on
Greenworks webpage)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A faulty
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
warranty. Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in
order to claim for warranty, together with the proof of
purchase (receipt).
10 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name: GLOBGRO AB
Globe Group Europe
Address: Propellergatan 1, 211 15 Malmö, Sweden
Name and address of the person authorised to compile the
technical file:
Name: Peter Söderström
Address: Propellergatan 1, 211 15 Malmö, Sweden
Herewith we declare that the product
Category:
Model:
Serial number:
Year of Construction:
• is in conformity with the relevant provisions of the
Machinery Directive 2006/42/EC.
• is in conformity with the provisions of the following
other EC-Directives:
6
19 mm
4.3 kg
80 dB(A),
K =3 dB(A)
PA
96 dB(A)
≤2.5 m/s
2
1.5 m/s
Pole Hedge Trimmer
PTC305
See product rating label
See product rating label
2