Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance, Overhaul, Repair; Maintenance; Overhaul; Repair - Stahl 9170 Serie Betriebsanleitung

Schaltverstärker
Vorschau ausblenden Andere Handbücher für 9170 Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Maintenance, Overhaul, Repair

EN
9
Maintenance, Overhaul, Repair
EN
 Comply with the applicable national standards and regulations in the country of use,
EN
e.g. IEC/EN 60079-14, IEC/EN 60079-17, IEC/EN 60079-19.
EN
9.1

Maintenance

EN
Check the following points in addition to the national regulations:
EN
• Whether the clamping screws holding the electrical lines fit securely
• Whether the device enclosure and/or protective enclosure has/have cracks or other visible
EN
signs of damage
EN
• Whether the permissible temperatures are complied with
EN
• Whether the parts are securely fastened
• Ensure it is being used as intended
EN
EN
9.2

Overhaul

The device does not require regular maintenance.
EN
EN
 Perform maintenance on the device according to the applicable national regulations and
EN
the safety notes in these operating instructions ("Safety" chapter).
EN
9.3

Repair

EN
 Repair work on the device must be performed only by R. STAHL.
EN
EN
10

Returning the Device

EN
 Only return or package the devices after consulting R. STAHL!
EN
Contact the responsible representative from R. STAHL.
EN
R. STAHL's customer service is available to handle returns if repair or service is required.
EN
EN
 Contact customer service personally.
EN
or
EN
 Go to the r-stahl.com website.
 Under "Support" > "RMA" > select "RMA-REQUEST".
 Fill out the form and send it.
You will automatically receive an RMA form via email. Please print this file off.
 Send the device along with the RMA form in the packaging to
R. STAHL Schaltgeräte GmbH (refer to chapter 1.1 for the address).
11

Cleaning

 Check the device for damage before and after cleaning it. Take damaged devices out of
operation immediately.
 To avoid electrostatic charging, the devices located in hazardous areas may only be
cleaned using a damp cloth.
 When cleaning with a damp cloth, use water or mild, non-abrasive, non-scratching
cleaning agents.
 Do not use corrosive cleaning agents or solvents.
14
Switching repeater
Series 9170/.1
200089 / 9170612310
2020-04-30·BA00·III·en·09

Werbung

Kapitel

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis