Stahl 9170 Serie Betriebsanleitung Seite 29

6.1.3 Mounting / Dismounting of the Device on DIN Rail and pac-Bus
Mounting on DIN rail
 Position the device on the DIN rail. Position the cut-out of the enclosure on the
outside edge of the DIN rail.
 Engage the device on the DIN rail.
 When swivelling the device onto the DIN rail, make sure that it is not set at an angle.
Mounting on pac-Bus
The pac-Bus is equipped with a polarisation guide and the device with a matching
polarisation slot.
 Position the device as shown in the illustration. Position the cut-out of the enclosure on the
outside edge of the DIN rail.
 Engage the device on the pac-Bus.
Dismounting
 Pull out the base bolt slightly using a screwdriver.
 Swivel out the device.
200089 / 9170612310
2020-04-30·BA00·III·en·09
Mounting and Installation
Switching repeater
Series 9170/.1
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
06886E00
EN
EN
EN
EN
EN
EN
EN
EN
EN
15554E00
EN
EN
EN
EN
06881E00
9