Installation - Stahl 9170 Serie Betriebsanleitung

Mounting and Installation
EN
6.1.4 Mounting / Dismounting on pac-Carrier
EN
See operating instructions for pac-Carrier Type 9195.
EN
6.1.5 Mounting / Dismounting pluggable Terminals
EN
All devices are equipped with pluggable terminals.
EN
Mounting
EN
 Insert the terminal into the device until the terminal engages.
EN
EN Dismounting
EN
EN
EN
EN
EN
EN
EN
 Position the screwdriver behind the terminal.
EN
 Push out the terminal.
EN
6.2

Installation

EN
Operation under difficult conditions, in particular on ships, requires additional
EN
measures to be taken for correct installation, depending on the operating location.
EN
Further information and instructions on this can be obtained from your regional sales
EN
contact upon request.
EN
6.2.1 Electrical Connections / Schematic Diagram
EN
See device labelling.
EN
EN
6.2.2 Connection of Supply
DANGER! Explosion hazard due to no safeguarding or incorrect safeguarding of the
auxiliary power!
Non-compliance may result in serious or even fatal injuries.
 Protect the device with an electrical back-up fuse, e.g. T 2A H.
 Ensure sufficient short-circuit current in the system
 Connect the main and auxiliary power according to the following scheme
(see table and chapter 15.1).
Device type
9170/.1-1.-1.
9170/.1-1.-21
10
Switching repeater
Series 9170/.1
(e.g. 24 V DC power supply. with a nominal output current of 4 A or higher).
Type of supply
Direct supply of the device via
24 V connection
Supply via pac-Bus
Direct supply of the device via
230 V connection
Supply not possible via pac-Bus
Connection
Green terminal "7+" and "9-"
pac-Bus terminal "1+" and "2-"
Green terminal "L" and "N"
–
200089 / 9170612310
2020-04-30·BA00·III·en·09
10859E00