Inhaltsverzeichnis
Werbung
en
Replacing the HEPA filter (motor protection filter)
If your vacuum cleaner is equipped with a HEPA filter, this
should be replaced once a year.
22*
Figure
Open the dust bag compartment lid.
Pull out the HEPA filter in the direction of the arrow and
remove it from the appliance.
Insert the new HEPA filter and close the dust bag
compartment lid.
Replacing the exhaust filter
You must replace the exhaust filter in your vacuum cleaner
once a year.
Replacing the micro-hygiene filter
23*
Figure
Open the dust bag compartment lid (see Figure 18).
Release the filter holder by pressing the locking tab in the
direction of the arrow
Remove the foam filter and micro-hygiene filter.
Insert the new micro-hygiene filter and foam filter into the
filter holder.
Insert the filter holder into the vacuum cleaner and clip
into place.
Replacing the HEPA filter
You can order a new filter from our after-sales service
using the following replacement part number: 574 020
24*
Figure
Open the dust bag compartment lid (see Figure 18).
Release the HEPA filter by pressing the locking tab in the
direction of the arrow and remove it from the vacuum
cleaner (see Figure 23).
Insert the new HEPA filter and clip into place.
If you have used the vacuum cleaner for fine dust parti-
cles (such as plaster or cement), clean the motor pro-
tection filter by tapping it and, if necessary, replace the
motor protection filter and the exhaust filter.
* Dependent on model
40
Care
Always switch off the vacuum cleaner and disconnect the
power cord from the mains before cleaning the vacuum
cleaner.
The vacuum cleaner and plastic accessories can be cleaned
with a commercial plastic cleaner.
Do not use a scourer, glass-cleaning agent or all-
!
purpose cleaning product.
Never immerse the vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned with a
second vacuum cleaner or simply wiped with a dry cloth or
dusting brush.
Subject to technical modifications.
Werbung
Inhaltsverzeichnis
