Makita AF353 Betriebsanleitung Seite 11

Air duster
CAUTION:
Do not aim the ejection port of the
air duster to someone. Also, keep your hands and
foot away from the ejection port. If the air duster
button is accidentally pushed, it may cause a per-
sonal injury.
CAUTION:
Always check your surroundings
before using the air duster. Blown dust or objects
may hit someone.
CAUTION:
Do not connect or disconnect the
air hose while pushing the air duster button.
The air supplied to the tool can also be used as an air
duster. You can clean the work area by pressing the
button on the grip end.
► Fig.10: 1. Button
NOTICE:
After using the air duster, the driving force
of the tool will temporarily decline. Wait until the air
pressure recovers in this case.
NOTICE:
Perform a test blow if you use the air
duster immediately after the oil was applied. The oil
may be sprayed with the air.
ASSEMBLY
CAUTION:
Before carrying out any work on
the tool, always return the trigger and lock lever
and disconnect the hose.
Loading pin nailer
CAUTION:
Hold the sliding door when press-
ing the unlock button. In case pin nails are loaded in
the magazine, the sliding door moves suddenly when
pressing the unlock button.
CAUTION:
Always move the sliding door
slowly and carefully. Accidentally dropping pin nails
especially when working in high places may cause
personal injuries.
CAUTION:
Load the same type, size and
uniform length of nails when loading nails in the
magazine.
NOTICE:
Load pin nails in the correct direction.
Loading in wrong direction may cause premature wear
and tear of the driver and damage of the other parts.
NOTICE:
Do not use deformed connected pin
nails. Use pin nails specified in this manual. Using
pin nails other than those specified may cause pin
nail jamming and breakage of the pin nailer.
1. With holding the sliding door, press the unlock
button and move the sliding door to open.
► Fig.11: 1. Unlock button 2. Sliding door
2. Place pin nails against the magazine and insert
into the slit all the way. Be careful to place pin nails in
the right direction.
3. Keeping pin nails in this position, slide these nails
all the way into the driver guide.
► Fig.12: 1. Pin nails 2. Driver guide
4. Return the magazine to the original position until
unlock button pops up.
Dimensions of nails
Only the following fasteners can be used with the tool.
23 Gauge pin nails
► Fig.13
Maximum
► Fig.14: (1) 35 mm
Minimum
► Fig.15: (1) 15 mm (2) 0.6 mm
Unloading pin nailer
To remove pin nails, follow the procedures of "Loading
pin nailer" in reverse.
Nose adapter
When driving pin nails on delicate surfaces, use the
nose adapter.
To install the nose adapter, place it over the driver guide
cover so that the protrusions inside the nose adapter fit
in the driver guide cover.
► Fig.16
A spare nose adapter is stored in the holder at the end
of the sliding door.
► Fig.17
Connecting air hose
CAUTION:
Do not rest your finger on the
trigger when connecting the air hose.
► Fig.18: 1. Air fitting 2. Air socket
Slip the air socket of the air hose onto the air fitting on
the tool. Be sure that the air socket locks firmly into
position when installed onto the air fitting.
A hose coupling must be installed on or near the tool in
such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
OPERATION
CAUTION:
Make sure all safety systems are in
working order before operation.
Checking proper action before
operation
Before operation, always check following points.
— Make sure that the tool does not operate only by
connecting the air hose.
— Make sure that the tool does not operate only by
pulling the trigger.
11 ENGLISH