Specifications - Makita BKP140 Betriebsanleitung

ENGLISH (Original instructions)
1. Button
2. Red indicator
3. Battery cartridge
4. Star mark
5. Pointer
6. Knob
7. Lock-off lever
8. Switch trigger
9. Planer blade
10. Rear base
11. Foot
12. Socket wrench
13. Bolt
14. Loosen
15. Tighten
16. Drum
17. Drum cover
18. Adjusting plate

SPECIFICATIONS

Model
Planing width
Planing depth
Shiplapping depth
No load speed (min
Overall length
Net weight
Rated voltage
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for planing wood.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS PLANER SAFETY
WARNINGS
1. Wait for the cutter to stop before setting the tool
down. An exposed cutter may engage the surface
leading to possible loss of control and serious injury.
2. Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
6
Explanation of general view
19. Inside edge of gauge plate
20. Blade edge
21. Screws
22. Heel
23. Back side of gauge base
24. Gauge plate
25. Gauge base
26. Pan head screw
27. Planer blade locating lugs
28. Heel of adjusting plate
29. Set plate
30. Inside flank of gauge plate
31. Back side of gauge base
32. Mini planer blade
33. Groove
34. Hex. flange head bolt
35. Nozzle
36. Dust bag
-1
)
ENE001-1
GEA010-1
GEB064-1
37. Fastener
38. Elbow
39. Start
40. End
41. Cutting line
42. Screw
43. Edge fence (optional accessory)
44. Sharpening holder
45. Wing nut
46. Blade (A)
47. Blade (B)
48. Side (D)
49. Side (C)
50. Limit mark
51. Chip cover
52. Screwdriver
53. Brush holder cap
BKP140
82 mm
1.6 mm
9 mm
13,000
329 mm
3.3 kg
D.C. 14.4 V
the work by hand or against your body leaves it
unstable and may lead to loss of control.
3. Rags, cloth, cord, string and the like should never
be left around the work area.
4. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
5. Use only sharp blades. Handle the blades very
carefully.
6. Be sure the blade installation bolts are securely
tightened before operation.
7. Hold the tool firmly with both hands.
8. Keep hands away from rotating parts.
9. Before using the tool on an actual workpiece, let it
run for a while. Watch for vibration or wobbling
that could indicate poor installation or a poorly
balanced blade.
10. Make sure the blade is not contacting the
workpiece before the switch is turned on.
11. Wait until the blade attains full speed before
cutting.
12. Always switch off and wait for the blades to come
to a complete stop before any adjusting.
BKP180
2 mm
14,000
333 mm
3.4 kg
D.C. 18 V