Specifications - Makita PC1100 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Front roller
2-2. Hex wrench
2-3. Base
3-1. Hex socket head bolt
3-2. Stock removal amount
4-1. Hex socket head bolt
4-2. Hex wrench

SPECIFICATIONS

Wheel diameter
Rated speed (n)/No load speed (n
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for planing concrete surfaces.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : planing concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
4-3. Base
5-1. Screwdriver
5-2. Screw
6-1. Same level
6-2. Square or ruler
6-3. Hex socket head bolt
7-1. Raise
7-2. Lower
8-1. Lock nut wrench
Model
Hole diameter
Spindle thread
)
0
Overall length
Net weight
Safety class
) : 88 dB(A)
pA
) : 99 dB(A)
WA
value (tri-axial vector
2
) : 4.0 m/s
h
2
ENE002-1
The declared vibration emission value has been
•
measured in accordance with the standard test
ENF002-1
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENG102-2
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG230-2
sum)
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Concrete Planer
Model No./ Type: PC1100
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
3
8-2. Lock nut
8-3. Shaft lock
8-4. Diamond wheel
9-1. Dust bag
9-2. Fitting
11-1. Dust cover
12-1. Limit mark
13-1. Brush holder cap
13-2. Screwdriver
PC1100
110 mm
15 mm
M12
-1
10,000 min
418 mm
4.4 kg
/II
Corporation as the
ENG901-1
ENH101-12
responsible