Setup; Unfolding The Handle - Toro 29732 Bedienungsanleitung

Setup

Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
Important:
To prevent accidental starting, do not
insert the key into the electric-start ignition (if
equipped) until you are ready to start the engine.
1

Unfolding the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the handle knobs and bolts from the
machine housing
2. Attach the handle to the machine housing
(Figure 3).
1. Bolt
(Figure 3).
Figure 3
2. Knob
3. Move the handle to the operating position
(Figure 4).
1. Handle knob (2)
Important:
of the handle as you unfold the handle
(Figure 5).
1. Cables
2. Wire harness
g032765
(electric-start model only)
4
Figure 4
Route the cables to the outside
Figure 5
Electric-start model shown
3. Handle
g032014
g025928