After Operation; After Operation Safety; Cleaning Under The Machine; Folding The Handle - Toro 29732 Bedienungsanleitung

•
If there are more than 13 cm (5 inches) of leaves
on the lawn, mow at a higher cutting height and
then again at the desired cutting height.
•
Slow down your mowing speed if the machine
does not cut the leaves finely enough.

After Operation

After Operation Safety

General Safety
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Remove the ignition key (if equipped) before
loading the machine for hauling.
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.

Cleaning under the Machine

Service Interval: After each use
For best results, clean under the machine soon after
you have completed mowing.
1. Lower the machine to its lowest cutting-height
setting.
2. Move the machine onto a paved level surface.
3. With the engine running and the blade engaged,
spray a stream of water in front of the right, rear
wheel (Figure 22).
Note:
The water will splash into the path of the
blade, cleaning out the clippings.
Figure 22
4. When no more clippings come out, stop the
water and move the machine to a dry area.
5. Run the engine for a few minutes to dry the
underside of the machine.

Folding the Handle

WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the ignition key (if equipped).
2. Loosen the handle knobs until you can move the
handle freely
1. Handle knob (2)
3. Move the handle forward as shown in
g002600
14
(Figure 23).
Figure 23
g032022
Figure 23.