Troubleshooting - ROWENTA POWER SPACE Bedienungsanleitung

CLEANING AND MAINTENANCE
5. Change the microfilter cassette*
(ref. RS-RT9501)
N.B.: Changing the microfilter* (ref. RS-
RT9501) every sixth bag change.
• Open the lid (9) of your vacuum cleaner - fig. 11.
• Withdraw the microfilter cassette * (14c) - fig.
20a.
• Separate the grey foam filter (14e) from the
microfilter (14d).
• Dispose of the microfilter (14d) in a waste bin
and replace it with a new Microfilter.
• Wash the grey foam filter (14e) with warm soapy
water (mild detergent). Squeeze it out and leave
it to dry for at least 12 hours.
Caution: Make sure that the grey foam filter is
completely dry before putting it back in place.

TROUBLESHOOTING

Important: As soon as your vacuum clea-
ner stops performing efficiently, and
before making any checks, stop it by pres-
sing on the On/Off pedal.
• Repairs should only be performed by
specialists using original spare parts. Repairs
carried out by the user can be dangerous.
Contact the nearest approved service centre or
Rowenta customer service (see details on the
last page).
1. If your vacuum cleaner does
not start
• The appliance is not powered: make sure the
appliance is properly connected.
2. If your vacuum cleaner does
not suck
• An accessory or the hose is blocked: unblock
the accessory or hose.
• The lid is not properly closed: check the
position of the bag and bag support (15) and
close the lid.
3. If your vacuum cleaner is not
sucking properly or is making
whistling noise
• An accessory or the hose is partially blocked:
unblock the accessory or hose
• The bag is full or saturated by fine dust:
replace the paper bag* or empty the textile
bag*.
• The foam-filter is saturated. Clean the foam-
filter.
*Depending on model: equipment specific to certain models or optional accessories.
• Re-fit the grey foam filter (14e) to the microfilter
(14d).
• Re-fit the microfilter cassette *(14c) in its
compartment - fig. 20e.
• Check that the microfilter cassette * (14c) is fitted
correctly before re-closing the lid (9).
6. Clean the vacuum cleaner
• Clean the housing of the vacuum cleaner with a
soft and humid rag and let dry.
• Clean the cover with a dry rag - fig. 21.
• Do not use abrasive or aggressive products.
• If the bag fill indicator stays red, the filtration
system is saturated.
- The Hepa* cassette: change the Hepa* cassette
and put it back in its housing.
- Washable HEPA* filter cassette: clean or
change the washable HEPA filter cassette and
put it back in its housing.
- The microfilter cassette*: withdraw the
microfilter from the cassette, and change it.
Wash the grey foam filter, squeeze it out and
leave it to dry for at least 12 hours.Then re-fit
the cassette in its housing.
• The electronic power regulator* is in the
minimum position: increase the power using
the electronic power regulator* (unless you are
cleaning fragile fabrics).
• The mechanical power regulator on the grip is
open: close the mechanical power regulator
4. If the bag full light stays red
• The bag is saturated: replace the paper bag* or
empty the textile bag*.
5. If the tool attachment is
difficult to move
• Open the regulator slot on the grip or decrease
power.
• Check that the position of the nozzle (21) is
suitable for the surface being hoovered: for
rugs and carpets use the nozzle with the brush
retracted, for wood and hard floors, use the
nozzle with the brush out.
14
EN