Storing And Transporting The Appliance - ROWENTA POWER SPACE Bedienungsanleitung

USE
1. Assemblage of the parts of
the appliance
• Push the flexible hose (17) securely into the
suction opening (10) until your hear a clicking
sound - fig.1.To remove it, press the button of
the hose connector and pull - fig.2.
• If your vacuum cleaner is equipped with the
telescopic tube* (18) : push the adjustment
knob forward, pull the desired tube length
out then release the button to lock - fig.3a.
Slot in the extension tube* (26) if necessary.
Otherwise, assemble the two tubes* (19),
turning them slightly - fig. 3b.
• Fit the desired accessory to the end of the
tube:
Choose the right accessory
- for rugs and carpets: use the 2-position
nozzle (21) on carpet position (retracted brush)
or the turbobrush* (fibres and animal hairs).
- for hard flat floors and hard flat floors with
crevices (such as tiled floors): use the 2-
position nozzle (21) on hard floor position
(brush extended), or for better results, use the
hard flat floor nozzle* (20B.a) without the
removable brush.
- for fragile hard flat floors, such as parquet, it
is recommended to use the hard flat floor
nozzle (20A) or (20B.b*).
N.B.: The nozzle for hard flat floor with cre-
vices 20B.a* is used to measure perfor-
mance associated with the energy label.
This nozzle allows you to optimise the
dust-collection performance
appliance on hard flat floors with crevices.
- For corners and areas which are difficult to
reach: use the slot tool attachment convertible
into a brush* (23) in the flat tool attachment
position.
- For upholstery and delicate surfaces : use the
crevice tool convertible into brush* (23) or the
upholstery nozzle* (22) or the brush integrated
to the nozzle (17).
IMPORTANT Always switch off and unplug
your vacuum cleaner before changing the
accessories.
*Depending on model: equipment specific to certain models or optional accessories.
2. Connecting the cord and
starting the appliance
• Unwind the power cord completely, plug
your vacuum cleaner in - fig. 4 and press the
On/Off pedal (2) - fig.5.
• Set the suction power:
- using the electronic power regulator (3) : turn
the switch on the electronic regulator : to set
the suction power: towards maximum
position for floors and minimum position for
furniture and fragile fabrics - fig. 6.
- with the mechanical power regulator on the
grip: open the slider on the grip to manually
reduce suction power, e.g.: on fragile
surfaces... - fig. 7.
3. Storing and transporting the
appliance
• After use, stop your vacuum cleaner by
pressing the On/Off pedal (2) and unplug it -
fig. 8. Wind the power cord by pressing the
cord winder pedal (4).
• In vertical position, put the telescopic tube*
(18) in its storage under the appliance (1b) -
fig. 9.
• In horizontal position, put the nozzle (21) in
its case at the back of the appliance (1a) - fig.
10.
• Carry your vacuum cleaner easily using its
carry handle (7).
of your
12
EN