Imetec R5701 Gebrauchsanleitung Seite 23

ATTENTION! For the use, cleaning, maintenance and storage
of the appliance, respect the indications given in the relative
chapters.
• Persons with a pacemaker must not operate this appliance when they are in bed:
it can be used to pre-heat the bed but it must be switched off and disconnected
from the mains supply before going to bed.
• DO NOT use the appliance with wet hands or damp feet.
• DO NOT pull the power cable or the appliance itself to unplug the appliance
from the mains supply..
• DO NOT pull or lift the appliance by the supply cord.
• DO NOT expose the appliance to humidity, to the effects of weather (rain,
sun, etc.) or to extreme temperatures.
• If the appliance is faulty or malfunctions, switch it off and do not tamper with it.
Contact an authorised technical service centre for any repairs.
• DO NOT use this appliance to warm animals.
• DO NOT tuck in.
• See the external packaging for the characteristics of the appliance.
PLACEMENT OF THE ANTI-MITE HEATED MATTRESS COVER
WARNING! The heated mattress cover must only be placed between
the mattress and the flat sheet and not on top of persons in bed.
The anti-mite heated mattress cover is supplied already assembled. Follow the
instructions to install the heated mattress cover correctly after cleaning and washing.
1. Spread out the mattress cover with the upper side facing down [Fig. A].
2. For the single model, spread out the heating panel (4) over the mattress cover so that
the press studs (5) are facing down and the panel connector (7) is positioned outwards.
For the double bed model, lay the two panels (4, 6) next to each other above the
mattress cover so that all the press studs (5) are facing downwards and the con-
nectors of both panels (7) are positioned outwards [Fig. D].
3. Secure the heating panels to the mattress cover by attaching the panel
press studs (5) to the corresponding press studs of the mattress cover (1)
[Fig. E].
4. Fold the mattress cover complete with panels and place it on the mattress, taking
care to pull the corners well so that no creases form [Fig. F].
5. Pass the control connector (15) through the eyelet (3) on the mattress cover so that
USE
EN
22