Automatic Switch-Off; Setting The Brewing Temperature - Bosch TES 501 Serie Gebrauchsanleitung

en
Important: If a water ilter is used (special
accessory order no. 461732), proceed as
follows, see „Water ilter" auf Seite 27.
Note: If no button is pressed within 90 sec­
onds, the appliance switches to stand­by
mode without saving the new settings. In
this case, the previously saved water hard­
ness setting is retained.

Automatic switch-off

Here you can set the period of time after
which the appliance should switch off au­
tomatically following the last drink prepa­
ration. A time between 15 minutes and 4
hours can be set. The default time is 1 hour,
but this can be shortened to save energy.
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
(12) simultaneously for at least 5 sec­
onds. The time after which the appliance
should switch off is indicated by the
number of LEDs that now light up.
3. Now press the start button (10) repeat­
edly until the required number of LEDs
light up to indicate the switch­off time:
D
= 15 minutes
D E
and = 30 minutes
D E F
, and
D E F
, , and
D E F G
, , ,
D E F G
, , , ,
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the
selected switch­off time has been saved
successfully.
TES501_1DE.indb 29
B A
(11) and
= 45 minutes
G
= 1 hour
H
and = 2 hours
H I
and = 4 hours
Note: If no button is pressed within 90 sec­
onds, the appliance switches to stand­by
mode without saving the new settings. In
this case, the previously saved switch­off
time is retained.

Setting the brewing temperature

The brewing temperature can also be set.
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
A
(12) for at least 5 seconds. The set
brewing temperature is indicated by the
number of LEDs that now light up.
3. Now press the start button (10) repeat­
edly until the required number of LEDs
light up to indicate the temperature:
D
LED = low
D E
LED and = medium
D E F
LED , ,and
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the
selected temperature has been saved
successfully.
Note: If no button is pressed within 90
seconds, the appliance switches to stand­
by mode without saving the new settings.
In this case, the previously saved brewing
temperature setting is retained.
29
B
(11) and
= high
TES501.. 08/2011
05.08.2011 15:34:47