Maintenance - SATA AE1032H Bedienungsanleitung

12. MAINTENANCE

CAUTION
The "Spare parts" handbook does not authorise users to carry out work on the machine with the
exception of those ope¬rations expressly described in the user manual. It only enables users to provide
the technical assistance service with precise information in order to minimise delays.
WARNING
SICE declines all liability for claims de¬riving from the use of non-original spare parts or accessories.
CAUTION
SAny operation intended to modify the set¬ting value of the relief valves or pressure limiter is
forbidden.
The manufacturer declines all liability for damage resulting from tampering with these valves.
WARNING
Before adjusting or servicing the machine, disconnect the electricity and compressed air supplies and
make sure that all moving parts are suitably immobilised.
CAUTION
Do not remove or modify any parts of this equipment except in the case of service operations.
DANGER
When the machine is disconnected from the air supply system, the devices marked with the warning
sign shown above may remain pressurised.
- The filter+regulator+lubricator is equip¬ped with a semiautomatic condensation drain device. This device operates
auto¬matically whenever the compressed air supply to the machine is cut off. Drain the condensation manually
(push¬button C, fig. 35) when the level exceeds the mark X, fig. 35.
- Clean the top plate of the turntable every week: remove any accumulated dirt and clean with environmentally-friendly
sol¬vents.
- Monthly checks:
• Clean the arms of the tool-carrying head, the bead breaking unit and the relative travel screws with environmentally-
friendly solvents only. Lubricate.
• Check the oil level in the air lubricator (fig. 35) and, if necessary, top up with non-detergent SAE20 oil to the indicated
level Z.
• Clean with a dry cloth. Avoid contact with solvents.
• Check the oil flow-rate through the transparent cover K (correct flow-rate: 1 drop of oil every 4 bead breaking cycles).
Adjust if necessary by turning the set screw Y fig. 35.
DANGER
Keep the working area clean.
Never use compressed air, jets of water or solvent to remove dirt or deposits off the machine.
When cleaning, take care not to create and raise dust as far as possible.
AE1032H
81
- 03 -
EN DE RU KO PT JA ES