Transport, Storage And Handling; Unpacking/Assembly - SATA AE1032H Bedienungsanleitung

2. TRANSPORT, STORAGE AND HANDLING

- The tyre changer must be transported in its original packing and stowed in the position shown on the external packing.
- Packing dimensions:
width 1140 mm
depth 1543 mm
height 1900 mm
- Weight of wooden packing: 380kg
- Temperature: -25°- +55°C
WARNING
Do not stack other goods on top of the packing to avoid damaging it.
Handling
To move the packing, insert the tines of a fork-lift truck into the slots on the base of the packing itself (pallet) (1-fig. 1).
Before moving the machine, refer to the HOISTING/HANDLING section.

3. UNPACKING/ASSEMBLY

WARNING
ake utmost care when unpacking, assem¬bling, hoisting and installing the machine as described in this heading.
Keep the original packing in good condi¬tions to be used if the equipment has to be shipped in the future.
Failure to comply with these instruction may damage the machine and risk the operator's safety.
- Remove the upper part of the packing.
- The machine is fully assembled, comprising two main groups, 2- the machine, 3- the ac¬cessories, (fig. 1).
- Identify the points 4 and 5 at which the machine is anchored to the pallet and proceed to remove fixing devices, (fig. 1)
- In order to remove the machine from the pallet, hook it up as shown in fig. 2.
- This hoisting point must be used whenever you need to change the installation position of the machine. Do not attempt
to move the machine until it has been disconnected from the electricity and compressed air supply systems.
AE1032H
( Fig. 1 )
47
- 03 -
EN DE RU KO PT
( Fig. 2 )
JA ES