Device-Status14) - VEGA VEGAPULS C 21 Betriebsanleitung

Example:
Command Response
aXWAPPL! 0+000<CR><LF>
Write access protection unlock with emergency code
Command Response
aXWAPEC <va- a<value1><CR><LF>
lue1>!
Example:
Command Response
0XWAPEC 0+000<CR><LF>
+0123456789!
13.5 Device-Status
Failure
Code
F013
F017
F025
F036
F040
F080
F105
F260
F261
F264
F265
Maintenance
Code
M500
M501
M504
Value 4 with aD0!, aR0!, aRC0!, value 2 with aD0! behind aV!
14)
VEGAPULS C 21 • SDI-12
14)
DesCRiption
No measured value available
Adjusted span too small
Error in the linearization table
No executable software
Error in the electronics
General software error
Measured value is determined
Error in the calibration
Error in the device setting
Installation/setup error
Measurement function
Description
Error in the delivery status
Error in the non-active linearization table
Error on an device interface
Description
Description
a: sensor address
<value1>: 10 numbers (device emergency unlock code)
<CR><LF>
<value1>: VVO-Status
Description
13 Anhang
55