FIMAR MSD/300P Benutz Und Wartungsanleitung Seite 57

▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ BELL PACKAGING MACHINE MCD
USE INSTRUCTIONS
Operation in "automatic mode"
1. Press the main switch (A) to turn on the appliance.
2. Use button (C-D-F-G) to set all operational parameters.
3. Insert the food product into bag.
4. Insert the bag into decompression chamber with the bag opening positioned on sealing
bar.
To package liquid products, fill the bag to the maximum level up to 50% of their capacity
and position them so that the opening is on sealing bar , while the product must be at a
lower level, inside the chamber, thus avoiding the product discharge.
5. Lower holding bell and keep it in position until the equipment does not end up the
sealing cycle of the bag.
– The pump creates the vacuum when the chamber is closed Display (B) briefly shows
the abbreviation "VAC" and then starts countdown of the programmed value.
– Sealing starts once the vacuum phase is completed. Display (B) briefly shows the
abbreviation "SEA" and then starts countdown of the programmed value.
– Heater cooling starts once the sealing phase is completed and display (B) shows the
abbreviation "COO".
– The display shows abbreviation "OPN" once the heater cooling phase is completed
to signal the bag has been packaged.
MCD / E
B C
V
A
D
- 25 -
E
F
S
G
EN
English language