Safety Regulations; Technical Data; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL LE-ST 360E Bedienungsanleitung

Anleitung LE-ST 360 E_SPK7
GB
1. Description
1 Power cable
2 Locking button
3 On/Off switch
4 Knurled screw for regulating the speed
5 Inspection guard
6 Saw blade
7 Guide roller
8 Adjustable base
9 Allen key

2. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
3. Use
The jigsaw is designed for sawing wood, iron, non-
ferrous metals and plastics using the appropriate
saw blades.
4. STARTING UP
Instant response operation (Figure 1)
Switching on: Press the On/Off switch
Switching off: Release the On/Off switch
Continuous operation
Switching on: Press the On/Off switch, keep pres
sed and lock with the locking button
Switching off: Press the On/Off switch and release
Electronic speed control setting (Figure 1)
Using the knurled screw on the On/Off switch you
can pre-set any speed. Turn the knurled screw in
PLUS direction for a higher speed and turn it in
MINUS direction for a lower speed. The ideal cutting
rate depends on the specific material and working
conditions.
The general rules for tool speed in cutting operations
apply.
Changing the saw blade (Figure 2)
Switch off the jigsaw and remove the plug from the
power socket before changing the blade or carrying
out any other work on the jigsaw.
10
29.05.2006 16:32 Uhr Seite 10
Use the supplied hexagon-socket spanner to undo
the two screws on the ram (Figure 2). Slide the saw
blade into the guide slot and up to the stop between
the piston rod and the retention clip. Use the
supplied hexagon-socket spanner to tighten the two
screws. The teeth of the saw blade must face in
cutting direction. Make sure that the saw blade sits
properly in the guide slot of the ram and roller.
Adjusting the base (Figure 3)
For mitre and bevel cuts you can swivel the base by
up to 45° in either direction after undoing the two
screws (a) on the bottom. The angles 15°, 30° and
45° are marked but you can adjust the saw to any
angle between these markings as required.
To adjust the cutting angle, undo the two screws (a)
until you can just about move the blade. Adjust to the
required angle and re-tighten the two screws.

5. TECHNICAL DATA

Nominal voltage:
Power consumption:
Cutting rate:
Stroke height:
Cutting depth in wood:
Cutting depth in plastic:
Cutting depth in iron:
Mitre cuts: up to 45° (left and right)
Sound pressure level LPA:
Sound power level LWA:
Vibration a w
Double isolation
Weight
6. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
230 V ~ 50 Hz
360 W
0-3000 min -1
18 mm
55 mm
10 mm
6 mm
88 dB(A)
103 dB(A)
13,69 m/s 2
II / ®
1,6 kg