Changing The Door Opening Direction; Tools Required - Fagor 1cfv15e Bedienungsanleitung

FQ8Y000A7 16/1/04 16:09 Página 43
Downloaded from www.Manualslib.com
CHANGING THE DOOR-OPENING DIRECTION:

TOOLS REQUIRED:

An Allen screwdriver.
PROCEDURE:
1. Unplug the freezer from the mains.
2. Undo the bottom hinge screws of the appliance
with a Phillips screwdriver. Take care that the
washers do not get lost.
3. Lift off the bottom hinge.
4. Remove the door.
5. Take out the top hinge pin and fit it on the other
side of the freezer. Take care that the upper
washer does not get lost.
6. Change the position of the lower hinge pin.
BEFORE SWITCHING YOUR FREEZER ON:
Clean the inside with warm water and bicarbonate of soda. Rinse and dry
carefully.
Wait for 2 hours before starting, to ensure that the motor lubricants have
stabilised.
If the appliance has been switched off, after switching it on again you have to
wait 4 hours before putting food items into the freezer.
manuals search engine
7. Set the upper washer and the door in place.
8. Refit the bottom hinge with its washers on the
other side of the freezer.
9. If fitted, change the lateral handles to the
other side.
Switch the appliance on and check that the
sealing strips seal properly when the door is
closed.
5