EINHELL PSE 500 Bedienungsanleitung Seite 7

BD-PSE-500 13.11.2001 13:57 Uhr
Caution:
Wear safety
goggles.
Attaching the sight
guard and the chip
shear protection
piece.
Sight guard Chip shear protection piece
2
G Always use an appropriate
saw blade which is in good
condition.
G Never operate the jig saw
without its blade.
G Occasionally lubricate the
rollers with a few drops of oil.
3
Buttons for swit-
ching on and off
To switch on:
Press operating
switch A.
Continuous ope-
ration:
Lock operating
switch A with
locking button
B.
To switch off:
Briefly press
operating button
A.
Seite 7
1
G Inserting the
saw blade:
Insert the saw
blade all the
way into the
blade socket
and securely
tighten.
Caution:
Ensure the saw
blade is in the
groove of the
direction of
operation.
Removing the saw blade:
Turn the hex screw
approx. 1 rotation to the
left.
G The saw can be operated
continuously, or momen-
tarily.
4
Step 1 =
600 stro-
kes per
minute
Step 6 =
3300 stro-
kes per
minute
Loosening the screw allows you
to adjust the saw to a 45˚ angle to
the left or right.
6 Cutting veneer press board:
Pocket cut: Only in fixing plate and wood without predrilling
Firmly press the jig saw against the pivot piece and move
slowly in the direction of the arrow.
GB
Turning the speed controller
to the right increases the
working speed; there are six
steps, 1 through 6.
0 = no oscillation, thin
workpiece
I = slight oscillation, thicker
workpiece
II = strong oscillation, fast
cutting
5
1. Fine saw blade:
2. Place the saw shoe
on the unlayered
side.
3. Slight pushing
force.
7