F) Setting The Volume/Muting; Other Functions - Conrad 44 92 38 Bedienungsanleitung

Submenu „AUDIO"
The following functions are available:
„BASS"
„TREBLE"
„BALANCE"
„SOUND MODE"
„AVC"

f) Setting the Volume/Muting

If the OSD menu is not displayed on the screen, you can use the buttons „" or „" on the IR-remote control or „UP/
+" and „DOWN/-" on the monitor to set the volume.
The corresponding display is shown on the screen.
The button „ " on the IR remote control may be used to mute the audio playback (this function is not available via the
buttons of the monitor).
g) Other Functions
• Use the button „PICTURE" on the IR remote control to choose between different settings for colour/contrast/brightness
(„USER", „STANDARD", „SOFT" and „VIVID").
The colour/contrast/brightness values for the selection „USER" can be set as desired in the OSD menu.
• The button „FREEZE" on the IR remote control has no function in this version of the monitor. When pushing the
button, the monitor shows „FREEZE UNSUPPORTED" (= function is not supported).
• For reasons of safety (since the monitor is intended specifically for operation as a surveillance monitor), the monitor
activates automatically when connected to operating voltage (or after interruption of operating voltage). The last
input selected is always selected as video input in this case.
38
Bass settings (amplification of the deep tones)
Treble settings (amplification of the high tones)
Balance settings (left/right)
Audio mode (presettings for different input signals, e.g. „MOVIE" for movie playback)
Automatic amplification control on/off