SWR Sound California Blonde II Bedienungsanleitung Seite 8

R R e e a a
R R e e a a
8
S. IEC POWER CORD SOCKET - Connect the included
power supply cord to a properly wired, grounded AC
electrical outlet in accordance with the voltage and
frequency ratings specified on the rear panel of your
amplifier.
T. FUSE - Protects the amplifier from electrical faults.
Replace a blown fuse ONLY with a fuse of the
type/rating specified on the rear panel of your
amplifier to protect your amplifier and maintain
warranty coverage.
U. COMBO CABINET OUTPUT - DO NOT unplug this
speaker connection. Your amplifier will be damaged if
powered on while disconnected. Intended only for
qualified service technicians during chassis removal.
V. REVERB FOOTSWITCH - Connect a standard latch-
type footswitch to enable remote on-off activation of
Reverb Defeat. (Reverb is defeated when the
footswitch is in the "closed" position.) Reverb Defeat
can be activated from either the front panel button or
the footswitch, but it can only be deactivated by the
same switch that activated it.
W. LINE OUT (CH 1) - Provides unbalanced Channel 1
preamp output for an auxiliary amplifier or sound
equipment. Channel 1 signal is disconnected from the
internal power amp when a plug is inserted into this
jack. This signal includes onboard tone shaping, the
effects loop signal, but not Reverb. Output level is
controlled by GAIN {H}.
California Blonde II Stereo Operation: When using the
STEREO INPUT {C}, connect the LINE OUT (CH 1)
jack to an external powered speaker (such as the
SWR ® Blonde on Blonde™) or the power amp input of
an auxiliary amplifier. Connect a stereo effects unit
using both Effects Loops (including both EFFECTS
BLEND controls) on the California Blonde II to create
a fully ambient stereo field.
Downloaded from www.Manualslib.com
r r P P a a n n e e l l
r r P P a a n n e e l l
s s w w r r s s o
manuals search engine
X. LINE OUT (CH 1+2) - Provides an unbalanced output
summed from both channel preamps for an auxiliary
amplifier or sound equipment. The power amp is NOT
disconnected when a plug is inserted into this jack.
This signal includes onboard tone shaping, the effects
loop signal, AND Reverb. Output level is controlled by
GAIN {H}.
Y. EFFECTS LOOPS (CH 1 and CH 2) - Jacks for
connecting your external effects units to each
channel. The SEND level is controlled by GAIN {H}.
The RETURN signal can be blended in any ratio with
the "dry" preamp signal using EFX BLEND {N}.
Use only shielded instrument cables with
standard 1/4" mono phone plugs with these jacks.
Use a stereo–to–mono adapter if your source has a
stereo plug. Connect EFFECTS SEND to your effects
device input, then connect the effects device output
to EFFECTS RETURN. NOTE: Set the wet/dry control
on external effects units to the fully WET position to
prevent phasing problems. Set the input level on
external effects as close to 0dB as possible.
The Effects Loop circuit is on a "side chain" of the
main circuit (as in studio recording consoles) to
provide the full sound of your instrument AND the
diversity of your effects units. Located after the gain
stages in the preamp signal path, this circuit also
reduces any noise generated by your effects units.
o u u n n d d . . c c o o m m