GYS NOMAD POWER PRO 90 Betriebsanleitung Seite 7

STARTING THE VEHICLE
Emergency start function for petrol or diesel vehicles with a 12V battery.
To start a vehicle, please process as follows:
!
If the voltage of the vehicle battery is > 12.5V, the NOMAD POWER will not function properly.
1
2
3
4
5
60"
6
7
If the engine does not start after doing the above steps, it means that the vehicle's battery could be drained excessively (excessively discharged
to less than 2V). Or a reverse connection. Please review the following steps:
60"
6b
7
NOMAD POWER PRO 90
Make sure the battery terminals on the vehicle to be boosted are well cleaned with no grease or corrosion.
Connect the booster cable plug into the booster cable socket.
1- Connect the red clamp to the (+) of the battery.
2- Connect the black clamp to the (-) of the battery.
Double check the connection. If the booster cable clamps are cross-connected on the vehicle's battery, please
correct them immediately.
Reverse connection will cause damage and explosion.
Press the power button (1) for 5 seconds. All four LED indicators will be illuminated successively.
Then, the LED indicator will show the level of battery status. It must be green light to work with jump start
function, if the capacity is low it may fail to jump start battery.
Press the Jump start button (2), all the LED indicators will be flash simultaneously
(If the LEDs are not flashing, see step 6b below) .
The jump start function will be activated. Please start the engine within 60 seconds
(the jump start function will switch off automatically within 60 seconds).
When the engine has been started successfully, please press the power button (1) for 5 seconds to switch off
the jump starter. Remove the booster cable clamps from the vehicle's terminal.
If the booster clamps are connected to the correct polarity, but LED indicators are not flashing. The voltage of
vehicle's battery might be too low, so the base unit could not identify the polarity. Please press and hold the
Jump start button (2) for 5 seconds to activate the jump start function FORCIBLY.
When all the LED indicators are flashing, please start the engine within 60 seconds.
The jump function will be shut down automatically after 60 seconds.
When the engine has been started successfully, please press the power button (1) for 5 seconds to switch off
the jump starter. Remove the booster cable clamps from the vehicle's terminal.
EN
7