Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
This manual contains safety and operating instructions. Read it carefully before using the device for the first time and
keep it in a safe place for future reference.
SAFETY
- Ensure someone is within hearing range, or close enough to come to your aid when you are working near a lead-acid battery.
- Have plenty water and soap nearby in case acid material contacts skin or eyes.
- Wear safety eye protection and protective clothing when you are working near the lead-acid battery.
- Using NOMAD POWER PRO in good working order and ventilated area.
- Only use the included recommended accessories for NOMAD POWER PRO. Using other unapproved accessories may be hazardous and invalidate the warranty.
- Do not smoke or generate a spark near the battery or engine.
- Do not put any metal objects onto or near the battery since it may cause a spark or short circuit to the battery, which could cause a explosion.
- Do not recharge the unit with damaged plugs, cables or accessories no attached.
- Do not store in the damp area.
- Do not allow the base unit to become wet and immerse it in water.
- Do not operate the unit in an explosive atmospheres, such as in the presence of flammable liquids, gases or dust.
- Do not modify or dissemble NOMAD POWER PRO, this will invalidate the warranty.
- In extremely cold temperatures, check for frozen electrolytic fluid before applying booster. Never charge or boost a frozen battery.
- Be sure each task is completed before removing clamps to prevent spark and potential explosion from battery gasses. Do not remove clamps while the unit is in use.
- Do not pull the clamps from the battery terminals.
- Never connect the clamp from the NOMAD POWER PRO to the car battery in reverse. Make sure that the red clamp is to the positive terminal and the black clamp
is to negative terminal. Reverse connection will cause damage and explosion.
- Make sure the insulation on all cables are not damaged before using the unit.
- Do not use the NOMAD POWER PRO for any task that it is not intend.
- Do not leave the unit in a discharged status for storage this will shorten its life.
- Be sure the internal lithium polymer battery is fully charged before using it.
- Charge and maintain the internal lithium polymer battery every 3 months.
- This product should be disposed of at an appropriate recycling facility. Do not dispose of in domestic waste.
This device is not intended for use by persons (including children) with reduced physical or mental capabilities, or lack of experience and knowledge, unless they have
been given by a person responsible for their safety, supervision or instructions concerning the use of the device. Children must no play with the product. Cleaning and
maintenance should not be performed by unsupervised children.
- Do not store or use the NOMAD POWER PRO under -20°C or above +40°C.
OPERATION
Indicators
Lights
Internal battery
capacity for the
device
Indicators flash in turn, whilst charging the device. 3. The green LED indicator will be illuminated when NOMAD POWER PRO is fully charged (It needs to be charged
when the orange LED indicator is illuminated in).
!
RECHARGE THE NOMAD POWER before first use and after each use.
INTERNAL BATTERY CHARGING
OR
6
NOMAD POWER PRO 90
Press the ON/OFF
button to check internal battery level of the NOMAD POWER PRO.
Red
Orange
25%
50%
1 - Connect mains adaptor to domestic mains.
2 - Connect the other end to the NOMAD POWER PRO to start the charge.
Disconnect the charger when the green LED indicator is on.
1 - Connect car adaptor to the car cigarette lighter socket.
2 - Connect the other end to the NOMAD POWER PRO to start the charge.
Disconnect the charger when the green LED indicator is on.
Yellow
Green
75%
100%
EN
Werbung
Inhaltsverzeichnis
