Errors; Maintenance; Warranty - Atag A Serie Bedienungsanleitung

9

Errors

Venting program active
10

Maintenance

11

Warranty

24
In the event of a failure (this is indicated by a c
and number code on the display) you can try to
eliminate the failure by pressing the Reset key.
If the failure persists, please contact the owner/
service department as soon as possible and tell
him the number code.
Please find the contact details on the back side
of this manual.
There are also messages with a c and a number
code that constitute no failures. These messages
will cancel themselves over time or after filling (or
draining) the heating system. Operating the reset
button has no effect then, for example:
c1 05 venting program active (approx. 7 min.)
c1 17 water pressure too high
c1 18 water pressure too low
If leaks occur in the installation, please contact the
owner/service department.
Please find the contact details on the back side
of this manual.
A maintenance agreement must be in in order
to have the installation periodically checked and
adjusted.
The cover of the boiler consists of plastic parts,
which can be cleaned with a normal (non-
aggressive) cleansing agent.
For the warranty conditions, see the Warranty
Card that has been delivered with the boiler.