Comfort/Eco Setting Of Hot Water - Atag A Serie Bedienungsanleitung

7

Comfort/Eco setting of hot water

The hot water supply has been preset in the
factory to Comfort. This means that hot water is
available instantly when you open the hot water
tap. If desired, you can choose the Eco mode.
This means that when tapping, it will take a little
longer before hot water will flow from the hot water
tap. This depends on the pipe length between the
boiler and water points and the current heating
temperature.
Changing the setting:
Press the OK key for 3 seconds.
OK
The display is showing 'P6 (alternated with) 81';
Press the Scroll key 1x;
ESC
The display is showing 'P6 (alternated with) 84';
Press the OK key;
The display is showing 'b0';
Press the Scroll key 1x;
The display is showing 'b1';
Press the OK key;
The display is showing 'on' (= Comfort);
Adjust the value by means of the + or - key to
'off' (= Eco);
Briefly press the OK key to confirm the new
setting.
The display is showing the chosen parameter
again
Press the ESC key until the default display is
shown again.
If during 8 minutes no key has been used,
the default display is displayed on the screen
automatically.
22