Operation - ELPRO ECOLOG TN2 Handbuch

5. Operation

5.1 Main Menu
Display „On"
Error 5, Module does not respond, during data reading
- The datalogger is not in the measurement mode
- To exit the menu press F1/F3
Seite - 18
Getting Started
ECOLOG
only appears if the logger is in power save
mode and data recording.
By pressing the menu key, the display is switched
on for a few seconds.
Start
only appears if the logger is in external start/stop
mode and is waiting for the external start signal or
the start time
Stop Statuscodes
Enter
only appears if the logger is waiting for the
external start by pressing F1
Resetting the alarm display
(only appears when an alarm display exists)
No function (exit menu)
THx: Time Stamp marked as D2
TNx: No function (exit menu)
TPx: No function (exit menu)
Printing the short protocol
Scrolling the
measured values
Scrolling the
alarms
Printing the
alarm protocol
and logger status
Setting the
k
internal cloc
LCD display test
OFF OFF
ON
Alarm output test
Submenu A
Submenu B
Prints: Entire protocol
Stop: Switches printer off
Submenu C
Exit menu
D-EZ-6003Bf
03. 2009