Sure Petcare SureFlap Schnellstartanleitung Seite 7

EN
3
x
x
4
5
6
7
15 to 30mm
8
9
10
Now it's time to prepare for cutting. We strongly advise that you
drill large holes in all the corners of the outline to make it easier to
cut the hole with a jigsaw. Make sure these holes are touching
the line and that they are big enough for the blade of the
jigsaw to fit through.
Using the jigsaw, cut around the outer edge of the line you have
marked. By doing this, the cat flap should fit through the hole first
time. However, if you cut on, or inside the line, the hole is likely to
be too small. If this is the case, please take the time to carefully
file the hole until the cat flap fits through easily.
Now check that the cat flap fits through the hole. Remember the
SureFlap logo must be inside the house. We advise that you have
two people for this, one inside the house and one outside to help
hold the product firmly in place.
On the outside of the house, make sure the tunnel of the cat flap
is securely pushed through the hole and then slide the external
frame over it. When the external frame is in place, using a sharp
pencil mark through the two holes.
Remove the external frame and the cat flap from the door then
drill the two screw holes using a 6mm (1/ 4 ") drill bit, remembering
to hold the drill horizontally. We recommend that you choose the
correct length of screw to attach the cat flap to your door at this
stage.
To choose the correct length of screw, from the sets provided you
need to compare the screw lengths to the thickness of your
door. The screw needs to be between 15 to 30mm (19/ 3 2 to 1 3/ 1 6")
longer than the thickness of your door.
Put the cat flap back through the door and slide the external frame
over the tunnel. Holding the product firmly in place, use a cross
head screwdriver and the screws you selected previously, to attach
the external frame. Fasten the first screw until it is secure, but not
too tight, then do the same to the last one. Once all the screws are
secure, tighten them.
Now, insert the two screw caps into the external frame.
EN
6