Optelec ClearView GO 15 Bedienungsanleitung Seite 30

Optelec
Additional mechanical safety precautions
Your ClearView GO has moving parts. Do not attempt to forcibly reposition or
adjust the parts. It may cause damage to the device.
Note: Use caution when moving parts or when transporting the ClearView GO to
avoid possible injury to hands and fingers.
Susceptibility to interference
There may be temporary degradation of the image when ClearView GO is
subjected to a strong radio frequency field, electrostatic discharge, or transient
electrical noise. An electrostatic discharge (caused by static electricity) may
cause the screen to go blank. If this happens, follow these steps:
1. Disconnect the DC adapter power supply from the electrical outlet.
2. Wait 30 seconds.
3. Connect the DC adapter power supply again.
Additional electrical safety precautions
Read these safety precautions before using ClearView GO:
• Using any power supply other than the one provided by Optelec for ClearView
GO will void the warranty.
• If using DC power, the ClearView GO device should be near a wall outlet that
is easily accessible.
• Do not use ClearView GO in, near, or around water. ClearView GO is not
designed to offer protection against contact with any liquids.
• Use only the power supply provided with your ClearView GO. Using
unauthorized power supplies may cause serious damage to ClearView GO's
electronic components.
• Always place the power cord away from traffic areas to avoid damage to the
power supply.
• Prevent the risk of electrical shock by NOT attempting to disassemble the
device. Refer all service to an authorized repair facility.
• Ensure that you make all proper cable connections.
30
ClearView GO
English