Setting And Starting Aprogramme; Setting Mode - AEG FAVORIT 54000 VI Benutzerinformation

D A B
30
20
A B D
3 0
2 0
SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come on.
If the control panel shows other condi-
tions, press and hold function buttons (B)
and (C) at the same time until the appli-
ance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Press the button of the programme
you want to set.
• The related programme indicator
stays on.
• All the other programme indicators
go off.
1.
2.
3.
C
4.
5.
A
-
+
C
CAUTION!
Use only detergents for dishwash-
ers.
Press the release button (B) to open
the lid (C).
Put the detergent in the compart-
ment (A) .
If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
If you use detergent tablets, put the
tablet in the compartment (A).
Close the lid. Make sure that the re-
lease button locks into position.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
again until the indicator of the number
of hours you want to set comes on.
You can set 3, 6 or 9 hours.
• The delay indicator comes on.
3. Close the appliance door. The count-
down starts. When the countdown is
completed, the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start
Press and hold function buttons (B) and
(C) at the same time until the delay indica-
tor goes off and all the programme indi-
cators come on.
ENGLISH
33