AEG FAVORIT 54000 VI Benutzerinformation Seite 38

38
Problem
Whitish streaks and
stains or bluish lay-
ers on glasses and
dishes.
Dry water drop
stains on glasses
and dishes.
The dishes are wet.
The dishes are wet
and matt.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press and hold function buttons (B)
and (C) at the same time until the indi-
cators of function buttons (A), (B) and
(C) flash.
Possible cause
The set level of the water
softener is incorrect.
The cap of the salt contain-
er is loose.
The released quantity of
rinse aid is too much.
The quantity of detergent
was too much.
The released quantity of
rinse aid was not sufficient .
The quality of the detergent
can be the cause.
• The programme had no
drying phase.
• The programme had a
low temperature drying
phase.
The rinse aid dispenser is
empty.
The quality of the rinse aid
can be the cause.
The quality of the combi
detergent tablets can be
the cause.
Possible solution
Make sure that the set level
of the water softener agrees
with the water hardness in
your area.
Tighten the cap.
Decrease the released quan-
tity of rinse aid
.
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Increase the released quanti-
ty of rinse aid.
Try a different brand of de-
tergent.
For better drying results,
keep the door ajar for some
minutes.
Make sure that there is rinse
aid in the rinse aid dispenser.
Try a different brand of rinse
aid.
• Try a different brand of
combi detergent tablets.
• Activate the rinse aid dis-
penser and use the rinse
aid together with the com-
bi detergent tablets.
4. Press function button (B).
• The indicators of function buttons
(A) and (C) go off.
• The indicator of function button (B)
continues to flash.
• The end indicator is off.
5. Press function button (B) to change
the setting.
• The end indicator comes on. The
rinse aid dispenser is active.
6. Deactivate the appliance to confirm.