Check List; Possible Cause - Masport MB Benutzerhandbuch

CHECKLIST
Problems
Integrated Ignition
When push the knob and turn anticlockwise:
- Won't light
- No spark
- Still no spark
- Weak spark
- Spark at places other than the tip of electrode
Electronic Ignition (Rear Burner)
When push the knob and turn anticlockwise:
- Won't light
- No spark
- Still no spark
- Still no spark
- Still no spark
- Weak spark
- Spark at places other than the tip of electrode
Burner can't light by match
Yellow or orange flames, with gas odour
Low heat with knob in "high" position
Flare up
Flame out
Flame lifting
Flashback
Grease fire
54

Possible Cause

Orifice blocked
Dirty contacts of the electrode and or loose
contacts
Electrode terminals are damaged
Due to moisture / food residue on the electrodes
Ignition wire damaged
Orifice blocked
Dirty contacts of the electrode and or loose
contacts
Dirty / loose contacts at the battery
Dead / discharged Battery
Wrong polarity
Circuit incomplete due Loose contacts at the
ignition module
Electrode terminals are damaged
Due to moisture / food residue on the electrodes
Ignition wire damaged
No gas
Gas flow is not smooth
Incorrect assembly between burner and valve
Incomplete combustion
Gas hose bent or kinked
Burner or orifice blocked
Low gas pressure
Grill not preheated
Excessive meat fat
Over high temperature
Grease deposit
Over high winds
Over high gas pressure
Burner port blocked
Grease accumulated in food
Solutions
Check the orifice for blockage
Remove the connecting wire, clean and reconnect
firmly
Inspect electrode and replace if damage
Remove the moisture using paper towel / clean the
electrode
Replace the ignition wire
Check the orifice for blockage
Remove the connecting wire, clean and reconnect
firmly
Clean
Replace battery
Check and insert the battery correctly
Re-assemble the ignition module make sure the
assembly is tight and makes a complete circuit
Inspect electrode and replace if damage
Remove the moisture using paper towel / clean the
electrode
Replace the ignition wire
Open the LP tank valve
Clear burner tubes
Re-assemble
Check the burner inlet for obstruction such as
spiders
Check air shutter for correct adjustment
Check for the source
Straighten
Clear
Check Cylinder/ Regulator (refer to pg. 15)
Preheat the grill for 15 minutes
Cut off fat before grilling
Adjust
Clean
Find a less windy place
Call the gas dealer
Clean
Turn off knobs, LP tank valve, leave lid open, let fire
burn out. Clean the grill when cool.