Product Description - Masport MB Benutzerhandbuch

A B
M4x12 M4x12
QTY x 2 x 8
*For stainless steel model BBqs - Fasteners I & J are not required.
CAUTION!
Although we take every effort to ensure that the assembly process is as easy as possible, it is inherent with fabricated steel
parts that corners and edged can cause cuts if improperly handled during assembly procedures. Be careful while handling any
parts during assembly. It is strongly recommended that you protect hands with a pair of work gloves.
Tools needed for assembly: Crosshead screwdriver, 10mm Spanner.
NOTE:
When assembling the barbecue, ensure it is sitting on a flat surface.
For illustration purposes a 6 Burner with Rear Burner is used in assembly steps shown in the next few pages. This
cabinet assembly is easier to assemble with two people.
STEP 1
Identify the two different types of legs. The left leg at the left front is the same as the right rear and the leg at the right front is the same as
left rear. Assemble the legs to the side panels.
34
FASTENERS
C D E
M4x12 M6
x 52 x 10 x 48
ASSEMBLY INSTRUCTIONS

Product Description

Carton Identification
Product Part Number
Open the carton by removing the
shipping straps then slitting along both
ends. Cut the tape only by a small
amount in the middle, finish by lifting the
carton flaps with your hand.
Unpack the entire carton, this carton will
be used as a surface protector as the
cabinet is being built. Open the carton as
shown and place where the BBQ will be
assembled
F G H
x 2 x 4 x 2
I J
x 4 x 4