Masport MB Benutzerhandbuch Seite 49

See following diagrams for further illustration:
FIGURE F1-OUTDOOR AREA-EXAMPLE 1
FIGURE F2-OUTDOOR AREA-EXAMPLE 2
Both ends open
FIGURE F3-OUTDOOR AREA-EXAMPLE 3
Open side at
least 25% of total
wall area
FIGURE F4-OUTDOOR AREA-EXAMPLE 4
Open side at
least 25% of total
wall area
FIGURE F5-OUTDOOR AREA-EXAMPLE 5
OTHER PRECAUTIONS
Do not obstruct any of the ventilation openings in the barbecue
body. Also, position the gas supply cylinder inside the cabinet, in
the cylinder base positioning hole. Should you need to change
the gas cylinder, confirm that the cylinder is off, and that there are
no sources of ignition (cigarettes, open flame, sparks, etc.) near
before proceeding. Be sure to inspect the gas hose and ensure it
is free of any twisting or tension. The hose should hang freely with
no bends, folds, or kinks, which could obstruct free flow of gas.
Apart from the connection point, no part of the hose should touch
any hot barbecue parts. Inspect the hose before use. If the hose
is damaged, it must be replaced with a hose suitable for use with
ULPG and meet the national standards for the country of use. The
length shall not exceed 1.5m. Should minimum clearances not
be adhered to severe flare up may be experienced due to lack of
airflow around the barbecue, thus voiding manufacturer's warranty.
GAS AND REGULATOR INFORMATION
This barbecue is designed for LP gas use only. Bottle sizes of 4.5kg
or greater are recommended for use with this barbecue. Suitable
LPG regulators must have an outlet pressure of 2.75 kPa. You must
have the proper regulator and bottle in order for the barbecue to
operate safely and efficiently. Please consult your local gas dealer
for the most suitable gas cylinders. Please note the regulator
supplied with this barbecue is of an approved type.
The manifold thread type is 5/8" x 18.
For more information on pipe sizing, please refer to AS/NZS 5601 /
AG601.
The gas cylinder must always be stored or used in an upright
position.
FIXING THE POL GAS REGULATOR TO THE CYLINDER
Confirm all barbecue control knobs are in the off position.
Hand-tighten the regulator supplied with this barbecue to the gas
cylinder by screwing in an anti-clockwise direction.
DO NOT OVER TIGHTEN!
As the regulator is fitted with a soft nose, it should only be tightened
30 percent or more in total
of the remaining wall area is
a further 1/4 turn after resistance is first felt.
open and unrestricted
30 percent or more in total
of the remaining wall area is
open and unrestricted
• Never leave burners on high for more than 10 minutes unless
actually cooking. If the burner makes hissing sounds when lit, it
Tighten in this direction
POL regulator
and hose
Protector Cap
OPERATION
WARNING!
Before proceeding, be certain you understand the safety
information contained in this manual.
This barbecue is not designed to be used with more
than 66% of the cooking area as a solid plate. Full
coverage of plates will cause excessive build-up of heat
and damage the barbecue.
Gas Shutoff Valve
Bleeder Valve Screw
Gas Cylinder
49