Inserting/Changing The Batteries; Battery Indicator In The Display - Bosch UniversalHumid Originalbetriebsanleitung

22 | English
Moisture meter
Dimensions
A) At an operating temperature of 25 °C
B) Normally only non-conductive pollution occurs, although occasional temporary conductivity
caused by condensation can be expected. Allow the measuring tool to acclimatise and remove
condensation from the pins before taking a measurement.
The serial number (8) on the type plate is used to clearly identify your measuring tool.
Assembly

Inserting/changing the Batteries

It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
To open the battery compartment, remove the battery compartment cover (9). Insert
the batteries.
When inserting the batteries, ensure that the polarity is correct according to the illustra-
tion on the inside of the battery compartment.
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
Tip: To easily remove the batteries, pull the strap in the battery compartment.
Slide the battery compartment cover (9) back on again.
Take the batteries out of the measuring tool when you are not using it for a pro-
u
longed period of time. The batteries can corrode and self-discharge during pro-
longed storage in the measuring tool.

Battery Indicator in the Display

The following table shows the correlation between the capacity/operating time of the
batteries and the battery charge indicator (e) in the display (3).
Display
1 609 92A 5EY | (29.04.2020)
UniversalHumid
187 x 56 x 44 mm
Capacity/operating time
75 % to 100 %
50 % to 75 %
25 % to 50 %
< 25 %
≤ 15 minutes of operating time
Bosch Power Tools