Parameterization Of The Cc-Link Interface (Cc-Link Slave); Resetting The Device (Reset Device) - HBM CA-CC-ET Bedienungsanleitung

22
field, the data rate to be used is derived from the various
settings, see AED/FIT component online Help. Possible settings
are 0  7 or 255. With a value of 255 (factory setting), the
gateway selects a good value, subject to the CAN baud rate
and the number of active AED/FIT stations.
Timer mode: The gateway generates a sync message on the CAN Bus in
cycles (factory setting). Specify the required cycle time in
milliseconds after Timer interval; the factory setting is 100 ms.
7.5 Parameterization of the CC‐Link interface (CC‐Link slave)
The CC‐Link slave setting dialog allows you to configure the gateways's
CC‐Link interface parameters.
CC‐Link baudrate
The permitted values are 156, 625, 2500, 5000 and 10000 kBit/s, the factory
setting is 156 kBit/s.
Station no.
Establishes the station number for the gateway. The permitted values are 1 
64, the factory setting is 1.
Occupied stations
Specifies the number of assigned stations for the CC‐Link interface. This also
establishes the number of containers that are available. The permitted values
are 1 to 4, the factory setting is 2.
Cycle time
Displays the mean PLC cycle time in milliseconds (ms) for the last 10 cycles.
Link state
Shows the status of the CC‐Link interface (OK/ERROR).

7.6 Resetting the device (Reset device)

Click Reset, to restart the gateway. This does not change the parameters,
although any parameters that may have been changed will be activated. The
process corresponds to switching the gateway off and back on again.
HBM
CC‐Link and Ethernet Gateway for AED/Fit components
A3330-1.0 en/de