Safety Instructions - Defort DBD-16N-1 Bedienungsanleitung

English
GB
BENCH PILLAR DRILL
THE NUMBERS IN THE FOLLOWING TEXT
CORRESPOND WITH THE PICTURES AT PAGE 2
TECHNICAL SPECIFICATIONS
PRODUCT INFORMATION
Fig.A
1. On/off switch
2. Drill depth gauge
3. Protection guard
4. Motor
5. Drill depth lever
6. Table adjustment
Check fi rst whether or not the delivery has been
damaged by transport and/or whether all the parts are
present.

SAFETY INSTRUCTIONS

The following pictograms are used in these instructions
for use:
Denotes risk of personal injury, loss of life or
damage to the tool in case of non-observance of
the instructions in this manual.
Denotes risk of electric shock.
Carefully read this manual before using the machine.
Make sure that you know how the machine functions and
how to operate it. Maintain the machine in accordance with
the instructions to make sure it functions properly. Keep
this manual and the enclosed documentation with the
machine.
When using electric machines always observe the
safety regulations applicable in your country to reduce
the risk of fi re, electric shock and personal injury.
Read the following safety instructions and also the
enclosed safety instructions. Keep these instructions
in a safe place!
1
Before using the machine the guidelines must be taken into
consideration. Every mechanical or electrical alteration to
the machine which does not meet the applicable guidelines
carries a considerable accident risk.
DURING USE THE FOLLOWING POINTS MUST
BE CONSIDERED:
• Do not remove any mechanical or electrical protective
provisions.
• Check whether all the protective provisions are in place
and have been attached correctly.
• Wear safety goggles during drilling.
• If you have long hair, be sure to wear hair protection
(hair net or cap). Long hair can easily be caught in
moving parts.
• Wear fi tted clothing; tie buttons on sleeves.
• Do not hold any workpieces in your hands when drilling.
Always use a machine clamp or another clamping tool.
• Protect workpieces and clamping tools on the bench to
prevent them from getting caught. Fasten them yourself
with screws or clamp them to a machine clamp fastened
to the table.
• Check whether the drill holder is tightened properly.
• Check whether cable lead-throughs are okay.
• To remove drill chips only use hand brushes, brushes,
rubber wipers, chip hooks or similar aids.
• Do not carry out any cleaning or greasing work while the
machine is in operation.
• Always keep V-belts covered (so that your hands cannot
become caught).
• Only tighten the toothed ring drill holder by means of the
wrench.
• Never leave the wrench of the drill holder in the drill
holder! Before switching on the machine, check whether
the wrench really has been removed!
• Do not use any drills which are damaged on the shank.
• Drill is not suitable to use as press!
• If the mains cable is damaged, it may only be replaced
by a mains cable of the same type.
IMMEDIATELY SWITCH OFF THE MACHINE
WHEN:
• Interruption in the mains plug, mains lead or mains lead
damage.
• Defect switch.
• Smoke or stench of scorched isolation.
ELECTRICAL INSTALLATION
The machine is provided with an electrical installation,
which meets the standards. Repairs may only be carried
out by a recognised professional.
The machine is provided with a zero voltage
switch. After the tension drops the machine will
not start to run automatically for safety reasons.
The machine must be switched on again.
ELECTRICAL SAFETY
Always check that the power supply corresponds to the
voltage on the rating plate.
Is an earthed mains power socket available?
3