Troubleshooting Guide - Kenwood FDM30 Bedienungsanleitungen

Tool/ Function
Attachment
Use to cut a variety of foods such as
carrot, courgette, cucumber, beetroot and
apples into cubes.
Use to cut a variety of foods into French
Fries and crudités such as potato, carrot,
courgette and cucumber.

Troubleshooting Guide

Problem
The processor will not
operate.
Blender or mill will not
operate.
Processor stops during
processing
Blender or multi mill
leaking from blade
assembly base.
Poor performance of
tools/attachments
Cause
No Power.
Bowl not fitted to power unit
correctly.
Bowl lid not locked on
correctly.
Blender or mill not locked on
correctly.
Blender or mill not assembled
correctly.
Processor overloaded/
maximum capacities
exceeded.
Lid unlocked.
Seal missing
Seal incorrectly fitted
Seal damaged.
Refer to hints in relevant 'Using the attachment' section. Check attachments
are assembled correctly.
2
Manual
Solution
Check processor is plugged in.
Check bowl is located correctly and the
handle is situated towards the right front
hand corner.
Check that the lid interlock is located
correctly into the handle area.
The processor will not work if the bowl
and lid are fitted incorrectly.
If none of the above check the fuse/circuit
breaker in your home.
The blender or mill will not operate if fitted
incorrectly to the interlock.
Check blade assembly is fully
tightened into the goblet/jar.
Check maximum capacities stated in the
recommended usage chart.
Check lid is locked correctly.
Check seal is fitted correctly and not
damaged. To obtain a replacement seal see
'Service and customer care'.
12
(Secs)
–
Do not fill
above the
maximum
capacity
marked on
the bowl