Cleaning The Hob; Troubleshooting - AEG IKE42640KB Benutzerinformation

16 www.aeg.com
• Use a special scraper for the glass.

7.2 Cleaning the hob

• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar,
otherwise, the dirt can cause damage
to the hob. Take care to avoid burns.
Use a special hob scraper on the glass
surface at an acute angle and move
the blade on the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
You cannot activate or oper-
ate the hob.
You cannot select the maxi-
mum heat setting for one of
the cooking zones.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
a non-abrasive detergent. After
cleaning, wipe the hob dry with a soft
cloth.
• Remove shiny metallic
discoloration: use a solution of water
with vinegar and clean the glass
surface with a cloth.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
You touched 2 or more sen-
sor fields at the same time.
Pause operates.
There is water or fat stains
on the control panel.
The other zones consume
the maximum available pow-
er.
Your hob works properly.
You put something on one
or more sensor fields.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Reduce the heat setting of
the other cooking zones
connected to the same
phase.
Refer to "Power manage-
ment".
Remove the object from the
sensor fields.